Power 1500W Portable Solar Energe PV System With 200W Folding Panels And 200A Battery

Introduction

There are two kinds of power generation methods in solar photovoltaic power generation system: one is photoelectric conversion mode, and the other is photoelectric direct conversion mode.

• Photothermal-electric conversion mode: by using the thermal energy generated by solar radiation to generate electricity, usually the solar collector will absorb the thermal energy into the steam of working medium, and then drive the turbine to generate electricity.The former process is the photothermal conversion process;The latter process is the heat - electricity conversion process, and ordinary thermal power generation.The disadvantage of solar thermal power generation is that its efficiency is very low and the cost is very high. It is estimated that its investment is at least 5 ~ 10 times more expensive than that of ordinary thermal power station. A 1000MW solar thermal power station needs an investment of 2 ~ 2.5 billion US dollars, and the average investment of 1 KW is 2000 ~ 2500 US dollars.Therefore, at present, it can only be used on a small scale for special occasions, while large-scale utilization is very uneconomical and cannot compete with ordinary thermal or nuclear power stations.
• Photoelectric direct conversion mode (photovoltaic power generation) : using the photoelectric effect, the solar radiation energy is directly converted into electric energy.The basic device for photoelectric conversion is the solar cell.Solar cell is a kind of effect by Yu Guangsheng volts and convert sunlight directly into electrical energy device, is a semiconductor photodiode, when the sun light to the photodiode, photoelectric diode will turn the sun's light energy into electrical energy (pictured), this way is easy to implement, and the cost is low, has been widely used.

System Diagram

The solar panel outputs direct current in the light.
The controller stored the direct current in the battery, or directly supplied to terminal load after being processed by inverter.
The controller, battery and inverter are located in the main machine.

Parameter Selection Table

Product Configuration Instructions

Tips:

The solar power PV system 1500W can be used for loads with 220V currents less than 6.8A.

As follows

Product Advantages

• It can generate electricity anywhere as long as there is light. High photoelectric conversion efficiency, zero consumption, no pollution;
• Integrated design of main machine, add handle, easy to carry;
• DC 5V 12V and AC110/220 voltage output, widely used in all kinds of electronic equipment, household appliances and instruments;
• Easy to install without charge. Place the solar panel and host, connect the wire can use;
• Complete protection function to ensure long service life of equipment. The design service life of solar panels is 25 years, the design service life of the host is 10 years, and the battery needs to be replaced in about 3~5 years according to the use of the situation.