Good thermal conductivity, this feature also determines that the spc floor can actually be used on the ground with floor heating. When there is floor heating at home, many decorators will recommend us to choose tiles as much as possible. But for bedrooms and other rooms, it is not suitable for laying tiles, so it is recommended that you learn about spc flooring. The raw material of the spc floor contains calcium powder, which can conduct heat quickly. Another very important point is that the spc floor will not volatilize and release toxic and harmful gases due to heating.

Inherent Security Features

In addition to formaldehyde free, our vinyl flooring products have 100% waterproof properties, NFPA Class B fire rating and R9 slip resistance performance. Its inherent safety features make our products perfectly meet the safety requirements for commercial and residential flooring.

Easy Installation

Our SPC flooring is provided with Unilin click systems for simple and quick installation, which makes no glue and no nails installation possible. Tiles/planks click into place with one simple movement. Besides, it can be easily installed on a variety of subfloors or existing flooring, saving your time and money.

Installation Steps

Precautions before installation

· SPC floor should be leveled and placed on site with constant temperature and stability for 24 hours before installation;

· Make sure the floor is smooth and clean before installing the floor, without any residue;

· When installing the floor, the indoor temperature should be kept between 15 and 28 degrees Celsius.Indoor temperature and

surface temperature 15 are appropriate, and should not be applied below 5 and above 30. The relative air humidity suitable for construction should be between 20% and 75%.

· The moisture content of the base layer should be less than 3%. The strength of the base layer should not be lower than the requirement of concrete strength C-20, otherwise suitable self-lev-eling should be used to strengthen the strength. The surface hardness of the base layer is not less than 1.2 MPa.

1. Before installation, it is recommended to spread floor film, which can make better feeling of feet and prevent the noise generated between the ground and the floor by small grains of sand. Put the first floor from the left corner of the room.

2. To prevent the natural expansion of the floor, 0.4 cm gap should be reserved between the wall and the floor.

3. When installing the first and second floor, insert the convex damage of the short side into the groove of the first floor,Continue to use the above method to install other floors...

4. When installing the last piece of the first row, you need to take the remaining part of the floor measure-ment first, and note that the floor needs to be measured in reverse.

5. Finally, use the art knife to force the floor surface, break it by hands easily, then install the last floor of the first row.

6. Start installing the second row,When installing the second floor, insert the convex of the short side into the groove of the previous floor, and gently insert the convex of the long side into the corresponding floor groove.

7. Use a rubber hammer when there are gaps.

8. Recommended installation method reference picture.

9. Finally, the same method can be used to install other floors in the room to ensure that necessary expansion gaps are left between all fixed vertical planes in the room, including doors, walls, cabinets and other fixed objects.