The materials used in SPC flooring are polyvinyl chloride stabilizers and calcium powder. A composite complex material formed by a certain proportion of mixing is a new type of green environmental protection material. Plasticized squeezed squeeze, and then four -roller pressure -delayed color -filter decorative layer. During the production process, it will not be made of glue containing formaldehyde. It belongs to an environmentally friendly floor that is 100 % without formaldehyde.

Advantages Of Spc Flooring

Stain Resistant

SPC flooring surface is covered with a special treated UV layer and wear layer that provide excellent stain resistance performance. Besides, SPC flooring is 100% waterproof and stains can be completely removed with a broom or a wet mop. It helps you saving a lot of time on flooring cleaning.

Flame Retardant

According to the statistics of authoritative departments:95% of the people injured in the fire is caused by toxic gas generated when burning. The main component of the SPC flooring is natural limestone powder, in case of fire, the SPC flooring has great flame retardant performance and will not produce asphyxiating toxic and harmful gas.

Precautions before installation

· SPC floor should be leveled and placed on site with constant temperature and stability for 24 hours before installation;

· Make sure the floor is smooth and clean before installing the floor, without any residue;

· When installing the floor, the indoor temperature should be kept between 15 and 28 degrees Celsius.Indoor temperature and surface temperature 15 are appropriate, and should not be applied below 5 and above 30. The relative air humidity suitable for construction should be between 20% and 75%.

· The moisture content of the base layer should be less than 3%. The strength of the base layer should not be lower than the requirement of concrete strength C-20, otherwise suitable self-lev-eling should be used to strengthen the strength. The surface hardness of the base layer is not less than 1.2 MPa.

1. Before installation, it is recommended to spread floor film, which can make better feeling of feet and prevent the noise generated between the ground and the floor by small grains of sand. Put the first floor from the left corner of the room.

2. To prevent the natural expansion of the floor, 0.4 cm gap should be reserved between the wall and the floor.

3. When installing the first and second floor, insert the convex damage of the short side into the groove of the first floor,Continue to use the above method to install other floors...

4. When installing the last piece of the first row, you need to take the remaining part of the floor measure-ment first, and note that the floor needs to be measured in reverse.

5. Finally, use the art knife to force the floor surface, break it by hands easily, then install the last floor of the first row.

6. Start installing the second row,When installing the second floor, insert the convex of the short side into the groove of the previous floor, and gently insert the convex of the long side into the corresponding floor groove.

7. Use a rubber hammer when there are gaps.

8. Recommended installation method reference picture.

9. Finally, the same method can be used to install other floors in the room to ensure that necessary expansion gaps are left between all fixed vertical planes in the room, including doors, walls, cabinets and other fixed objects.