Non - flammable Rigid Core Vinyl SPC Flooring Damp Proof Click System

Rigid Core SPC Flooring is the perfect choice for high-traffic and wet areas such as kitchens, bathrooms, laundry rooms, and basements. This flooring has a rigid core made from natural limestone powder, polyvinyl chloride, and stabilizers, which makes it waterproof, stable, and strong. It also has a vinyl layer that provides the decoration and a wear layer that protects it from scratches and stains.

Product Features

If you want a flooring that can handle any challenge, you should choose Rigid Core SPC Flooring. This flooring has a rigid core that is waterproof, fireproof, and dent-resistant, making it suitable for wet and high-traffic areas. It also has a vinyl layer that offers a natural and elegant look of wood or stone, and a wear layer that protects it from fading and wear. Rigid Core SPC Flooring is also comfortable and quiet underfoot, thanks to its cushioned underlayment. It is easy to install over any subfloor and does not need acclimation.

UTOP SPC FLOOR COLOR

Easy Installation

Rigid Core SPC Flooring is the perfect choice for high-traffic and wet areas such as kitchens, bathrooms, laundry rooms, and basements. This flooring has a rigid core made from natural limestone powder, polyvinyl chloride, and stabilizers, which makes it waterproof, stable, and strong. It also has a vinyl layer that provides the decoration and a wear layer that protects it from scratches and stains. Rigid Core SPC Flooring is easy to install over any existing subfloor and does not require glue or nails.

Installation Steps

Precautions before installation

· SPC floor should be leveled and placed on site with constant temperature and stability for 24 hours before installation;

· Make sure the floor is smooth and clean before installing the floor, without any residue;

· When installing the floor, the indoor temperature should be kept between 15 and 28 degrees Celsius.Indoor temperature and

surface temperature 15 are appropriate, and should not be applied below 5 and above 30. The relative air humidity suitable for construction should be between 20% and 75%.

· The moisture content of the base layer should be less than 3%. The strength of the base layer should not be lower than the requirement of concrete strength C-20, otherwise suitable self-lev-eling should be used to strengthen the strength. The surface hardness of the base layer is not less than 1.2 MPa.

1. Before installation, it is recommended to spread floor film, which can make better feeling of feet and prevent the noise generated between the ground and the floor by small grains of sand. Put the first floor from the left corner of the room.

2. To prevent the natural expansion of the floor, 0.4 cm gap should be reserved between the wall and the floor.

3. When installing the first and second floor, insert the convex damage of the short side into the groove of the first floor,Continue to use the above method to install other floors...

4. When installing the last piece of the first row, you need to take the remaining part of the floor measure-ment first, and note that the floor needs to be measured in reverse.

5. Finally, use the art knife to force the floor surface, break it by hands easily, then install the last floor of the first row.

6. Start installing the second row,When installing the second floor, insert the convex of the short side into the groove of the previous floor, and gently insert the convex of the long side into the corresponding floor groove.

7. Use a rubber hammer when there are gaps.

8. Recommended installation method reference picture.

9. Finally, the same method can be used to install other floors in the room to ensure that necessary expansion gaps are left between all fixed vertical planes in the room, including doors, walls, cabinets and other fixed objects.