GKBM GL-S5565-1

New Eco-friendly E0 Formaldehyde Unilin Click Granite Grain Stone Polymer Composite SPC Flooring

Manufacturer: GKBM

Brand: Greenpy

Series: Granite Grain Series

Decoration layer: floral granite grain

Product Name: Stone Plastic Composite Flooring (SPC Flooring)

Normal size: 1220*183mm (7*48”), 304.8*609.6mm (12*24”)

Thickness: 4mm, 5mm, 5.5mm, 6mm

Wear Layer: 0.3mm, 0.4mm, 0.5mm, 0.6mm

IXPE mute mat (optional)

IXPE thickness: 1 mm, 1.5mm, 2 mm

Application: home, school, kindergarten, dormitory, postpartum care center, office, hotel,

gym, hospital, library, shopping mall, store, dancing room, training room, exhibition hall,

fitness room, drawing room, basement, Eco-Industrial zone, etc.

Formaldehyde: E0

Fireproof: B1

Antibacterial species: Staphylococcus, E.coli, fungi

The antibacterial rate against Escherichia coli and Staphylococcus aureus reaches 9999%

Residual indentation: 0.15-0.4mm

Heat Stability: Dimensional change rate ≤0.25%,

Heating warpage: ≤2.0mm,

Cold and hot warpage: ≤2.0mm

Seam Strength: ≥1.5KN/M

Warranty: 20-30 Years

Packing: Carton

Single pack: 1238*195*55mm

13 pcs/carton; 2.9m2/carton.

Specificattions

Advantages

Note:

If you need 90° herringbone splicing method, please contact the factory for OEM service and MOQ.

Floor Installation Loss

Under normal circumstances, for normal splicing method, the floor paving loss is 3% to 5% of the actual floor area. For herringbone pattern splicing method, the paving loss is about 10% to 13% of the actual floor area.

For special room structures or special needs, the floor loss is subject to actual loss.

Installation Notes:

1.The temperature should be kept between 10-30 °C;

Place SPC floors at a constant temperature for 24 hours before paving;

the humidity should be kept within 40%.

2. Basic ground requirements:

(1) The height difference within the 2m level shall not exceed 3mm, otherwise self-leveling cement construction is required to level the ground.

(2) If the ground is damaged, the width should not exceed 20cm and the depth should not exceed 5m, otherwise it needs to be filled.

(3) If there are protrusions on the ground, it must be smoothed with sandpaper or leveled with a ground leveler.

3. It is recommended to lay a silent pad (moisture-proof film, mulch film) with a thickness of less than 2mm first.

4. A minimum 10mm expansion joint must be reserved between the floor and the wall.

5. The maximum length of horizontal and vertical connection must be less than 10m, otherwise it must be cut off.

6. During the installation process, do not use a hammer to forcibly hit the floor to prevent damage to the floor slot (groove).

7. It is not recommended to install and lay it in places such as bathrooms and toilets that are soaked in water for a long time.

8. It is not recommended to lay in outdoor, open-air balcony sun room and other environments.

9. It is not recommended to lay it in places that are not used or inhabited for a long time.

Maintenance:

1. Use a professional floor-specific cleaner to clean up the floor dirt, and maintain it every 3-6 months.

2. Avoid scratching the floor with sharp objects, do not push or pull when placing furniture, you’d better put protection pads (covers) on the table and chair feet.

3. Avoid direct sunlight for a long time, and you can block the direct sunlight with curtains, glass heat insulation film, etc.

4. If exposed to a lot of water, please remove as soon as possible, and reduce the humidity to the normal range.

Ordering Info: