Reusable Adult Soft tip spo2 Sensor Probe adult finger clip spo2 sensor for GE Marquette compatible 11pin

Compatibility:

The process flow for manufacturing is as follows:

Wire cutting: The wires are cut to the required lengths.

Sheath Stripping: The outer sheath of the wires is stripped to expose the inner conductors.

Shield Twisting: If there is a shield layer, it is twisted around the inner conductors for added protection against interference.

Sleeve Crimping: The sleeves or connectors are crimped onto the ends of the wires to facilitate proper connections.

Tin Soldering: The exposed conductors are coated with tin solder to enhance conductivity and ensure secure connections.

End Pressing: The crimped sleeves or connectors are securely pressed onto the ends of the wires.

Set Plastic Shell: A plastic shell or housing is set around the assembled components for structural integrity and protection.

Electrical Test: The assembled components are tested for proper electrical functionality to ensure they meet the required specifications.

Internal Mold Forming: If needed, an internal mold is formed to provide additional support and structure to the assembled components.

Outer Mold Forming: An outer mold is formed around the internal components to provide further protection and aesthetic appeal.

Visual Inspection: The assembled product is visually inspected to check for any defects or abnormalities.

Electrical Test: Another round of electrical testing is conducted to ensure the product's electrical performance.

Thread End of Network: If applicable, the network thread end is prepared for connection.

Sheath Stripping: The outer sheath of the network thread end is stripped to expose the inner conductors.

Shield Twisting: The shield layer is twisted around the inner conductors for added protection.

Tin Soldering: The exposed conductors are coated with tin solder for secure connections.

Chips Welding: Chips or electronic components are welded onto the network thread end.

Glue Dispensing: Adhesive or glue is dispensed to secure components and provide stability.

Assembly: The various components are assembled together according to the product design.

Final Test: The fully assembled product undergoes a final round of testing to ensure it meets all specifications and standards.

Packaging: The finished product is packaged and prepared for shipping or distribution.

This process flow outlines the general steps involved in manufacturing the product. However, please note that specific details and variations may exist depending on the product and manufacturing requirements.

Compatible MR Water Trap Product Manuals.pdf