CPD Continuous Disc Plate Dryer Technical Parameters

1. Drying Tray
- Designing pressure: generally 0.4Mpa, and the max. pressure is 1.6 MPa.
- Max. working pressure: generally ≤0.4Mpa, and the max. pressure is 1.6 MPa.
- Heat source: steam, hot water, or thermal oil: Use hot water as heat source when the drying plates' temperature is 100°C; Use saturated water steam ≤0.4Mpa or steam-gas when the drying plates' temperature is 100°C~150°C; Use thermal oil when the drying plates’ temperature is 150°C~320°C;

2. Material Transmission System
- Revolution of main shaft: 1~10 rpm, electromagnetism or transducer timing.
- Rake arm: 2 to 8 rake arms will be fixed on the main shaft on the every layer.
- Rake blade: the rake blades are hinged to the rake arms and float with the surface of the plate. There’re several types of rake blades.
- Roller: For the material that is easy to agglomerate, or required to be grinded, the rollers shall be placed at the appropriate place to reinforce the heat transfer and drying process.

3. Three types of dryer body: normal pressure, sealed, and vacuum
- Normal pressure: The dryer body is cylindrical or octagonal and the structure can be integrated or separated. The ducting system for the heat source can be placed inside or outside of the dryer.
- Sealed: The dryer body is cylindrical and it can bear the interior pressure of 5KPa. The ducting system for the heat source can be placed inside or outside of the dryer.
- Vacuum: The dryer body is cylindrical and the design pressure is 0.1MPa. The ducting system for the heat source is placed inside of the dryer.

4. Air Heater
The air heater is usually used to meet larger evaporation capacity requirements in order to increase drying efficiency.

CPD Continuous Disc Plate Dryer Technical Parameters

CPD Continuous Disc Plate Dryer Show