Hex Head Flange Bolt Of Hexagonal Half Tooth Bolt For Machine

Quick Details:
Name: Stainless Steel Set Screws Of Hexagonal Half Tooth Bolt
Material: 304 Stainless Steel , Alloy Steel
Size: M4 - M26
Service: OEM, ODM for customer's brand Trade term: FOB/EXW/CIF
Certificate: ISO, GB Function: Screws fastener for Machine, building, industry, lamps , Furniture ect.

Shipping Way: Boat, Train, Air Plane, Express

Products Description

The improved positioning device is shown in the figure below. At this time, change the installation sequence of the tail column, first extend the cylinder pin, then put the parts in, and position them in the front and rear direction (X direction) of the assembly. At this time, if the tail column is not installed in place, Hex Head Flange Bolt is not aligned with Electrical Contact Slotted Sealing Set Screws Drilled Hole Head Capstan Screws , the spring is in a compressed state, and the spring pin is also in a retracted state, but when the tail post is installed in place, the positioning hole is aligned with the spring pin, and the spring pin will automatically move from the positioning hole. Eject, position the part in the up and down direction (Y direction) of the assembling table, then close the clamp of the part. In this way, under the premise of ensuring the accurate installation of the tail column, the problem of parts being ejected by the cylinder pin during the installation process is avoided, the installation time of the parts is greatly shortened, the production cycle is improved, and the deformation of the parts by the cylinder pin is also avoided. problem.

Hex Head Flange Bolt specially used to fix the relative position of the machine. When in use, the set screw is screwed into the screw hole of the machine to be fixed, and the end of the screw is pressed tightly on the surface of another machine, even if the former machine is fixed on the latter machine. Slotted and hexagon socket set screws are used on parts where nail heads are not allowed to be exposed, and square head set screws are suitable for parts where nail heads are allowed to be exposed. The compression force of the screw is the smallest with the slotted screw, the largest with the square head screw, and the hex socket screw in the center. Cone-end screws are suitable for parts with small strength; non-pointed cone-end screws are suitable for parts with dents on the pressing surface to increase the ability to transmit loads;

Hex Head Flange Bolt Of Hexagonal Half Tooth Bolt​ Parameter