Brass Pipe TUBE COIL C2700 BRIGHT ANNEALED OD 10 X WT 0.7 mm

C27000 Brass Tubing, Brass Tube Pipe Tubing, Mill Test Seamless Brass Tubing, Brass Tube Round, 1mm 2mm 3mm 4mm 5mm H65 C27000 CZ107 CuZn36 C2700 Brass Tube China Supplier

C27000 Brass Tubing Feature:
1) Up to ASTM B 135 / BSEN 12449 / DIN 17765 / JIS H3300 standards
2) Material Brand of Common Brass Tube:

3) Tubes temper: H, 1/2 H, 1/4H or soft, all tempers are available.
4) Dimensions: OD: 5-350mm, WT: 0.5-50mm, or according to the buyers requirements, and also length and tolerance subject to the buyer’s decisions
5) Tubes in good straightness, with clean surface of both inside and outside
6) With pre-shipment inspection if needed, chemical report, mill test if asked, marked tensile strength, yield strength, elongation rate etc.
7) Typical use of common brass tubes:

Our brass pipe with low strength, thermal conductivity, good electrical conductivity,and H96 performance is similar, the strength is slightly higher, can be plated metal, all kinds of water supply and drainage pipe, double metal pieces and medals, art, etc.High strength, plastic good, suitable for cold, heat processing welding and good corrosion resistance, condensation and heat pipe, coil, siphon, cooling equipment parts,And H85 similar performance, high strength, good plasticity, corrosion resistance is higher, thin wall pipe, corrugated pipe network and housing construction supplies Good plasticity, high strength, good machinability, welding, corrosion resistance, heat exchanger, paper making, machinery, electronic parts,The performance is very similar to H70, but the cold work has the tendency of “seasonal crack”, complex cold punching and deep drawing, such as corrugated pipe.Have good mechanical properties, can withstand the cold and heat processing, for the production of daily necessities, hardware, screws and other parts,Have good mechanical properties, thermal plasticity good, good cutting, welding, good corrosion resistance, deep extension and bending fracture mechanical parts, such as pin, nut, a pressure meter spring, heat dissipation, annular parts Is a widely used lead brass, with good mechanical energy, is good machinability, can withstand cold and hot pressure processing, suitable for cutting and stamping processing of various structural parts, such as gaskets, bushing, etc. C26000 C27000 Brass Tubing C24000 C26200 Brass Tubing