0.6m - 4m steel bar Reinforcing concrete welded wire mesh machine , high efficiency Welding Wire equipment

Welding Wire equipment Specifications:

The Welding Wire equipment process:

• №1 Pretreatment, rough production line
• Steel wire pretreatment(including:Pay-off stand + Disorderly parking+New type(water clean)+ Electrolytic pickling + boron coating + High frequency drying + LZ6/560 straight-line wire drawing machine + SG800 I-spool take-up machine or none stop take-up machine
• №2 Fine drawing production line
• FX800 I-spool(or rotary ) wire pay-off machine + LZ8/400(or LZ7/400)Straight line wire drawing machine + Tension stand + Wash tank + SG630I-spool wire take-up machine
• №3 Chemical copper plating production line
• №4 Layer and packing production line
• SG630 spool pay-off machine (active type) + middle + layer winding machine
• №5 S4525 heat shrinkable packaging machine for packaging, warehousing

production equipment parameter

1. Wire material surface pre-treatment

1.1 high shelf pay-off: Put a wire rod, without motor

1.2 Scribble and automatic stop switch: wire out

of the pay-off machine through the steel ring with

a diameter of 200 mm, if a few circle wire

entwined, steel ring that was taken to the other

side, t the bottom of the stroke switch will send

signals, and the entire line emergency stop.

1.3 Repeated bending mechanical shell and

wire ball strong scrubbing device: the wire rod

at least six direction perpendicular(National

initiative)Bending heat treatment to strip iron

oxide on the surface of the wire.

Eight peeling wheel, material: ZG45 steel, hardness of HRC50, Wheel

inner diameter Ф 115 --- Ф 120mm.

Wheel service life of 6000 hours. After

peeling ,the wire through period of tapered hole, use wire clean ball strongly wipe the

surface of wire rod, and does not damage

the wire surface, reduce the waste into the electrolytic pickling tank, ensure the

effect of pickling, facilitate drawing; By pressure cold water irrigation and block and

impurities, rust on the surface of the wire rod export high-pressure gas blowing

device, reduce by wire out of the water.

Take-up system:

№1 Ф800mm I-Spool take-up machine

① Main transmission adopts the transmission efficiency high service life long V transmitte take form;

②) With pneumatic brake and pneumatic top

device

③ Motor:15 kw variable frequency motor；

④ Ribbon cable with screw thread, maintenance

is simple and practical

⑤ take up by Ф800mm I-spool

⑥ There were equipped with a mechanical locking device, at any speed, power outages, fly out to ensure that the wheel will not hurt workers

№2 Ф500mm Trunk-type Unloading Machine

The speed mach with Wire drawing machine.Single layer take-up,The surface of drum plat WC.Dia of drum is 560mm, take-up plate is 500kg, The machine have:2 take-up plate,2 wheel Barrow.Motor : 15KW

Technology parameters

• Overall dimensions (L*W*H) 4500*840*1720(mm)
• Max packing dimension (W*H) 270*100(mm)
• Packing Speed 10-13 sets/min
• Max sealing length 200mm
• Conveyor horizontal hight 800+30(mm)
• Working pressure about 0.5Mpa
• Power source 50Hz/AC380Vthree phase five wire
• Power(Max) about 15kW