0.4mm - 2.0mm cored welding wire / solid welding Wire Mesh Panel Welding Machine

• the wire diameter:1.5-2.5mm or 2.5-6mm
• the hole size:20mm(min)
• plc control full automatic
• roll mesh or sheet mesh all is ok

Main machine of Welded Wire Mesh Machine

Specifications for your reference:

• Wire dia:0.4mm-2.0mm
• Mesh size:12.7mm-50.8mm
• Welding width:91.4mm,1219.2mm,1524mm
• Working power:380V 50-60HZ
• Machine size:2350×1820×1200mm
• Weight: 2.5tons
• Welding speed:110 radia

Welding Wire machine Description:

Automatic production line for high speed wire welding is through the introduction of Swiss SCHLATTER company technology, after digestion, absorption, and research and development of a device, mainly composed of pay-off stand, wire frame, a longitudinal bar straightening device, longitudinal reinforcement traction device, storage rack, longitudinal reinforcement secondary straightening device, longitudinal reinforcement stepping feeding device, welding host, transverse reinforcement automatic feeding device, shearing machine, mesh network collection device, network transmission of orbit, it is mainly used for concrete road, building, tunnel, subway, water conservancy, such as prefabricated steel fabric in the construction field. This product production efficiency is high, the annual output can reach 50000 tons.

Features:

1. At present, a lot of other domestic products applicable to weld straight bar steel, need to manually wear reinforcement, the intensity of labor is big, the production efficiency is low. This project product is suitable for the plate steel, which can realize continuous welded steel fabric, improved the production efficiency.

2. Adopts two-way 45 ° inclined type straightening machine, straightening effect is good, all straightening roller can be adjusted through a hand wheel, convenient adjustment.

3. Longitudinal reinforcement stepping feeding device is convenient to adjust the longitudinal spacing, suitable for welding for a variety of specifications of the mesh. (patented)

4. Welding host selection for double impact cylinder, cylinder made by the company independent research and development, welding frequency up to 120 times/min, greatly improving the welding efficiency.

5. The transverse reinforcement automatic feeding system, without manual, the system consists of PLC program control, which can realize the continuity of transverse reinforcement accurate feeding.

6. Finished product mesh collecting device is composed of shrinkage, mechanical hand, lift orbits, which can realize the automatic mesh pallet, placed neatly, high production efficiency.

Welding Wire machine parameter

1. Wire material surface pre-treatment

1.1 high shelf pay-off:Put a wire rod, without motor

1.2 Scribble and automatic stop switch: wire out

of the pay-off machine through the steel ring with

a diameter of 200 mm, if a few circle wire

entwined, steel ring that was taken to the other

side, t the bottom of the stroke switch will send

signals, and the entire line emergency stop.

1.3 Repeated bending mechanical shell and

wire ball strong scrubbing device: the wire rod

at least six direction perpendicular(National

initiative)Bending heat treatment to strip iron

oxide on the surface of the wire.