Drying Tunnel Ovens SHR-01B Series Board Supporting Chain Conveyor

Customized stainless steel board supporting chain +rail conveyor, with less running wear, long service life, more stable and reliable.
Multi-channel design, greatly expand the capacity of products in the furnace, large capacity.
It can be configured with multi-channel connection, which can realize automatic loading and unloading and reduce labor cost.
Full modular design, convenient maintenance, reduce maintenance time and cost.
Patented hot air system, more efficient hot air convection conduction, faster heat compensation.
New furnace structure design, multi-layer heat insulation, effectively reduce the working environment temperature.

Features:

• Stage temperature control, to adapt to the process requirements of different products, PID temperature control, with good furnace temperature uniformity and better curing quality;
• Hot air circulation, high thermal efficiency, the total power is small, saving more than 25% power than the traditional equipment;
• Special heat insulation structure, the surface temperature of the machine housing is close to the room temperature, reduce energy;
• Modular design, flexible configuration, can meet various process requirements, especially for the products require for long baking;
• It can be used with automatic production line to effectively control manpower, reduce handling, reduce defects, save time and save input cost.

Application range:

• Suitable for magazine type curing;
• Suitable for multi-channel conveying (6-channel, 10-channel, 16-channel, etc.);
• Suitable for Mini LED solidification baking required for long curing time, large production capacity and high curing requirements;
• Suitable for PCB, LED, Mini LED, capacitor, power supply and other components baking process; It covers a wide range of fields electronic products, automotive electronics, semiconductors, 3C products, etc.

Overall diagram:
01 Front and rear side buffering
02 Monitor
03 Chamber lifting unit
04 Heating module
05 Bottom chamber module
06 Top chamber module
07 Conveyor system
08 Conveyor motor
09 Exhaust system

Options:

• Cooling system

1. Pressure charged air cooling
2. Water chiller

• Nitrogen system
• MES interface
• Temperature profile interface
• Buffering system

1. Multi-channel buffer
2. With shifting connection

• Preheating system

The preheating length can be customized.

• Conveyor system

1. Conveying width can be 500mm, 850mm, or to be customized
2. Multi-channel design

• Rack

1.Reserve the installation position for the fixture

• Customized conveying rails

The guide rail conveying mode can be customized according to the product process requirements.

Product Parameters:

Notices:
1.Power requirements:
①Three phase five wire: voltage 380V, frequency 50/60HZ;
②The wire diameter requirement is 16mm² or more, with a leakage protection switch of 125A and a leakage capacity of 150-200mA.
2.The ground is required to withstand a pressure of 1000kg/m².
3.External ventilation requirements: Duct specification 2-Ø150mm; Two exhaust ports, with a single exhaust port having an exhaust volume of approximately 15M³/min.