GPS Land Survey Equipment Agriculture Vehicle Measuring Instrument Slope Measurement Tool

Round-trip machine load of GPS land survey equipment:

Round-trip machine load is used to measure the area of agricultural machinery back and forth work,put the Land meter in the middle of the vehicle width as far as possible,set the width of the front-end operation of agricultural machinery,and then carry out back and forth work measurement.

①At the Round-trip machine load in parameter setting,press the ▲▼button to set the width.

②After setting is completed,press the start to return main interface.

③Press the▲▼button switch function to“Round-trip machine load”in the main interface；

④Press【Start】button at the starting point to start the measurement at the beginning of the work.

⑤Press the【Stop】button to pause measurement and view data after agricultural machinery work is completed；If the measurement is not completed,press the 【Start】 button again to continue the measurement. If the measurement is completed,press start to save the data.

Note: clicking "data" here will not display real-time data, and the current measured area must be calculated by clicking "pause".

• Length and width area measurement

①In the main interface,press the ▲▼to switching function to “Length and width”.

②At the starting point A press the【Start】button to measure,and press the【Enter】button to save the point A,go to the inflection point B,and press the【Enter】button to save the point B,go to the inflection point C,press the【Enter】button to save point C.

③Press the【Stop】button to end measurement and view data,and press start to save the data.

Note: if you want to end the measurement before 3 points are collected,Press the【Stop】button to pause the measurement.

• Fixed width area measurement

①At the Fixed width in parameter setting, press the ▲▼button to set the width.

②After setting is completed,press the start to return main interface.

③Press the▲▼button switch function to “Fixed width”in the main interface；press the【Start】button to measure in starting point；Press【Stop】button to pause measurement when measuring to the bottom line and view data；If the measurement is not completed, press the【Start】button again to continue the measurement. If the measurement is completed,press start to save the data.