Irregular Terrain GPS Land Survey Equipment

Product Parameters Of GPS Land Survey Equipment:

Product function introduction of GPS land survey equipment:

Measuring Methods of GPS land survey equipment:

First, press up and down button to choose a measuring mode;

1. Normal mode : at the starting point, press [Start/Stop] button to measure in the main surface; return to the starting point in a circle around the

ground, press the [Start/Stop] button to pause the measurement data. Press the "power" button to end measurement and save data.

2. Normal distance mode:at the starting point, press [Start/Stop] button to start measuring ;Walk along the measuring line to the end point and

press the [Stop] button to stop the measurement and view the measurement data;If the measurement is not completed,press the[Start] button

again to continue the measurement. If the measurement is completed,press "power" button to save the data.

3. Multi-point mode:At the land starting point,press the up and down button switch function to “Multi-point Distance ”.Press the [Start] button to

start measuring.Then press the [Enter] button to collect the information of the points.Finally,press the [Stop] button to stop the measurement

and view the measurement data; If the measurement is completed,press "power" button to save the data.

4. Mountain Mode : at the mountain top, press [Start/Stop] button to start measuring the mountain area.Now, it is the point A; Reach to the bottom

of the mountain, it is the point B. Press the [enter] button to save point B information; then walk around the bottom of the mountain, press

[enter] button when you finished. press the [Start/Stop] button to pause the measurement data, [start] to go on and press the "power" button to

end measurement and save data.

5. Intell Slope : at the starting point, press [Start/Stop] button to measure in the main surface; walk around the slope and press the [Start/Stop]

button when you finished. Press the [Start/Stop] button to pause the measurement. Press the "power" button to end measurement and save

data.

6. Round-trip Machine Load : In this mode, you could measure the area while the farm machine’s working. First, set the value number in

Parameter Round-trip setting. Then press [Start/Stop] button to start measuring while working. Press [Start/Stop] button to check when

working is done. Press [Start] to go on when it’s not finished. Press the "power" button to end measurement and save data.

7. Slope Mode : Set slope in Parameter setting before measuring. Then press [Start/Stop] button to measure in the main surface; walk around

the slope and press the [Start/Stop] button when you finished. Press the [Start/Stop] button to check the measurement data. Press the

"power" button to end measurement and save data.

System Setting Of GPS Land Survey Equipment:

Voice Volume:

① On the home page of boot,press the 【Settings】button to enter the settings interface；

② Press the▲▼button move to“System setting”；Press the【Enter】button to enter；

③ Press the【Enter】button to the voice volume;

④ Press ▲▼ button to adjust the value of number.

HDOP Limitation:

① On the home page of boot,press the 【Settings】button to enter the settings interface；

② Press the▲▼button move to“System setting”；Press the【Enter】button to enter；

③ Press the【Enter】button to the HDOP limitation ;

④ Press ▲▼ button to adjust the value of number；

⑤ After finishing setting,press the "Stop" button to exit.

Note: Measurements can only be made if the HDOP value is lower than or equal to the set value.