10/100/1000M SFP Copper RJ45 CAT5E CAT6 100m Gigabit 10GBASE-T Ethernet Transceiver Module

Description

10/100/1000base SFP Copper RJ45 is high performance, cost effective module compliant with the Gigabit Ethernet and 10/100/1000BASE-T standards as specified in IEEE 802. 3-2002 and IEEE 802.3ab, which supp- orting 1000Mbps data- rate up to 100 meters reach over unshielded twisted-pair category 5 cable. The module supports1000 Mbps full duplex data-links with 5-level Pulse Amplitude Modulation (PAM) signals. All four pairs in the cable are used with symbol rate at 250Mbps on each pair. The module provides standard serial ID information compliant with SFP MSA, which can be accessed with address of A0h via the 2wire serial CMOS EEPROM protocol. The physical IC can also be accessed via 2wire serial bus at address ACh.

Features

• Up to 1.25Gb/s bi-directional data links
• Hot-pluggable SFP footprint
• TX Disable and RX Los/without Los function
• Fully metallic enclosure for low EMI
• Low power dissipation (1.05 W typical) Ø Compact RJ-45 connector assembly
• Access to physical layer IC via 2-wire serial bus
• 10/100/1000Mbps compliant in host systems with SGMII interface
• Operating case temperature range of 0°C to +70°C (Commercial) -20°C to +85°C (Extend)​

Application

1.25 Gigabit Ethernet over Cat 5 cable

+3.3V Volt Electrical Power Interface

Pin Definitions

Compatibility

All of Takfly's transceiver modules are open sourced, can be coded to be fully compatible with major brands' products and devices, such as Intel, Dell, , Finisar, Arista, HP, Mellanox, Juniper, HUAWEI, H3C, etc.

For other brands' devices, please specify when ordering so that we can write corresponding codes for your easy application.

Dimension