Lightweight 57W P2.9 Car Rear Window LED Display For Media Platform Advertising

Description

3U View Rear Window LED Display is a new mobile media platform that could display advertisements. Different from the traditional media, 3U View vehicle LED screen is able to switch advertisements intelligently according to location and traffic information through the built-in GPS module.If you’re looking for a product that has the performance and the ads effect that you need. 3U View is the best choice for you!

Advantages

1. With GPS modules, the car can be tracked and located.

2. 3U View Rear Window LED Display is anti-vibration, totally high temperature and moisture-proof. Which is also featuring electrostatic prevention and light protection to make it more durable for the long-term usage.

3. The transparent design make the rear window view will not be completely covered. It is more safe while driving and parking.

4. It support 4G and WiFi, which has advertising release system and cluster control. Meanwhile, GPS, secondary development are introduced as well.

Product Parameters

FQA

Q: How to install the Rear Window LED Display?

A: Rear Window LED Display can be installed in two ways .

1. Fixed setting. It is fixed to the back seat with mounting bracket.

2. Using special glass glue, paste the LED Display onto the rear window of the car.

Q: What is the difference between the two installation ways?

A: 1. The fixed setting is suitable for sedan car, which has a better anti-vibration effect. The structure is made of steel.

2. Hatchback car using the nano adhesive paste method. The structure is made of transparent plastic board, which is much thinner than the steel structure.

Q: How to connect power cables?

A: The yellow wire is connected to the battery positive, the black wire is connected to the battery negative, and the white wire is connected to the cigarette lighter on the car.

Q: Why using three wires to control the screen?

A: In order to better protect the battery on the car, the extra white line is the trigger line, avoiding the screen is still operating after the vehicle shutdown, which will cause the loss of the car battery.

Installation Instruction

1. Fix the screws on the left and right sides of the mounting rack.

2. Fix the small bracket for upper partition.

3. Place the bracket in the rear seat gap and attach the power cord connector.

4. After the seat is restored, put the power cord into the gap between the seats.

5. Connect the fuse to the corresponding fuse holder, the red wire is connected to the positive pole, the black wire is connected to the negative pole, and the control wire is connected to ACC.

6. The effect picture after installation.

Rear Window LED Display Case