Hard Rock Drill Bits IADC735 7 7/8 Inch Patented Advanced Grease For Coal Mine

Advantage:

Propessional Equipment---- No matter raw material selection, or processing technology are selected is the industry leading technical equipment.

61 Years History---- From 1958 to 2019, customers are located all over the world and win a good reputation.

High quality----strictly act according to the ISO9001 standard, and all bits are manufactured according to strict standards, set forth by the American Petroleum Institute (API).

What is Hard Rock Drill Bits

1. classified according to characteristics set forth by the International Association of Drilling Contractors (IADC).
   
2. All bits the above are manufactured according to strict standards, set forth by the American Petroleum Institute (API).
   

Hard Rock Drill Bit is cut rock by Tungsten Carbide teeth projecting from rolling cutters, which rotate on the drill-bit bearings. Inturn, the drill bit rotates at a high rate, and presses against the bottom hole with a high axial force.

The teeth of the rolling cutters roll over the bottom hole and, owing to the large stresses that develop in the area of contact between the teeth and the rock, cut the rock by crushing and chipping. As the hardness of therock increases, the rotation rate decreases and the axial force increases.

Destroyed at the mine the rock is removed to the surface by air compressor, mud pump, or a combination of these methods.All bits the above are manufactured according to strict standards, set forth by the American Petroleum Institute (API).

classified according to characteristics set forth by the International Association of Drilling Contractors (IADC).

Working theory of TCI tricone bit

The medium formation TCI tricone bits features aggressive chisel tungsten carbide inserts on the heel rows and inner rows. This design provides a fast drilling rate and added cutting structure durability in medium to medium hard for mations. The HSN rubber O-ring provides adequate sealing for bearing durability.

Tricone bit is connected with the drill stem and rotates along with it, and drive cones to pressed on the rock. Each cone rotates round the axis of its leg and three cones simultaneously revolve around the bit center. The tungsten carbide inserts on the cone shell cause the formation to spall under the weight on bit and the impact load of cone rotating, the debris will be discharged out to hole by compression air.


How to read an IADC Code properly

Best Service for Tianying drilling bit

1. 24/7/365 after Service are committed even during holidays.

2. Within 35 Working Days Quick Delivery
3. Provide professional technical services, including products introduction, selecting and problem solution etc.