10.1 Inch Lcd Panel 1280x800 Lvds Interface 40 Pins High Brightness
General Description:
R101B40-226-0101 operating temperature is -20℃~70℃,storage temperature is -30℃~+80℃,operating ambient humidity is 10~90%RH,storage humidity is 10~90%RH.
Specifications:
Parameter | Specification | Unit |
Active Area | 216.96(H)*135.6(V) | mm |
Number Of Pixels | 1280(H)×800(V) | pixels |
Pixel Pitch | 0.0565(H)×RGB×0.1695(V) | mm |
Pixel Arrangement | Pixels RGB stripe arrangement | |
Display Mode | Normally Black | |
Display Colors | 16.7M(6bit +Hi-FRC) | colors |
Surface Treatment | HC | |
Contrast Ratio | 1000:1(typ.) | |
Viewing Angle(CR>10) | 80/80/80/80(typ.) | |
Response Time | 35(typ.)/40(max.) | ms |
Color Gamut | 50%NTSC | |
Power Consumption | Panel: 0.7(Typ.) | watt |
Outline Dimension | 221.96(H)*144.43(V)*1.06(typ)(FOB -Panel) | mm |
Absolute Maximum Ratings:
Parameter | Symbol | Min. | Max. | Unit | Remarks | |
Power Supply |
LCD Module |
VDD |
VSS-0.3 |
3.6 |
V |
Ta = 25 ℃ |
Operating Temperature | TOP | -20 | +70 | ℃ |
|
|
Storage Temperature | TST | -30 | +80 | ℃ | ||
Operating Ambient Humidity |
Hop |
10 |
90 |
%RH |
||
Storage Humidity | Hst | 10 | 90 | %RH |
Electrical Specifications:
Parameter |
Symbol |
Values |
Unit |
|||
Min. | Typ. | Max. | ||||
Power Supply Voltage |
VDD | 3.0 | 3.3 | 3.6 | V | |
VRP | 300 | mV | ||||
Power Supply Current | IDD |
- |
212 | 364 | mA | |
Power Consumption | PLCD |
- |
0.7 | 1.2 | W | |
Rush current | IRUSH |
- |
- |
3.0 | A | |
CMOS Interface |
Input Voltage |
VIH | 2.7 | 3.3 | V | |
VIL | 0 | 0.5 | V | |||
Output Voltage |
VOH | 2.7 | 3.3 | V | ||
VOL | 0 | 0.5 | V |
Interface Connection:
Pin No. | Symbol | Description | I/O |
1 | NC | Non Connection | - |
2 | VDDIN |
Power supply VDDIN=3.3V (Typ.) |
P |
3 | VDDIN | P | |
4 | VDDIN | P | |
5 | NC | Non Connection | - |
6 | GND | GROUND | P |
7 | GND | GROUND | P |
8 | RIN0- | LVDS Negative data signal (-) | I |
9 | RIN0+ | LVDS Positive data signal (+) | I |
10 | GND | GROUND | P |
11 | RIN1- | LVDS Negative data signal (-) | I |
12 | RIN1+ | LVDS Positive data signal (+) | I |
13 | GND | GROUND | P |
14 | RIN2- | LVDS Negative data signal (-) | I |
15 | RIN2+ | LVDS Positive data signal (+) | I |
16 | GND | GROUND | P |
17 | LVDS_CLK- | LVDS Negative CLK signal (-) | I |
18 | LVDS_CLK+ | LVDS Positive CLK signal (+) | I |
19 | GND | GROUND | P |
20 | RIN3- | LVDS Negative data signal (-) | I |
21 | RIN3+ | LVDS Positive data signal (+) | I |
22 | GND | GROUND | P |
23 | NC | Non Connection | - |
24 | NC | Non Connection | - |
25 | GND | GROUND | P |
26 | NC | Non Connection | - |
27 | NC | Non Connection | - |
28 | GND | GROUND | P |
29 | NC | Non Connection | - |
30 | NC | Non Connection | - |
31 | LED- |
LED Cathode |
O |
32 | LED- | O | |
33 | LED- | O | |
34 | NC | Non Connection | - |
35 | NC | Non Connection | - |
36 | NC | Non Connection | - |
37 | NC | Non Connection | - |
38 | LED+ |
LED Anode |
P |
39 |
LED+ |
P |
|
40 | LED+ | P |
Optical Specification:
Item | Symbol | Condition | Min | Typ. | Max | Unit |
Viewing Angle |
θL |
Cr≥10 |
70 | 80 | -- |
deg |
θR | 70 | 80 | -- | |||
θT | 70 | 80 | -- | |||
θB | 70 | 80 | -- | |||
Contrast Ratio | Cr |
θ=0° FF=0° |
-- | 1000 | - | |
Response Time | Tr+Tf | -- | 35 | 40 | ms | |
Color Coordinate of CIE1 931 |
Rx |
θ=0° |
-- |
- |
||
Ry | -- | |||||
Gx | -- | |||||
Gy | -- | |||||
Bx | -- | |||||
By | -- | |||||
Wx | -- | |||||
Wy | -- | |||||
NTSC Ratio | NTSC | CIE1931 | 45 | 50 | -- | % |
Gamma | - | 1.9 | 2.2 | 2.5 | ||
Polarization Direction of Front Polarizer |
- |
0 | deg | |||
Polarization Direction of Rear Polarizer | PdR | 90 | deg |
Handling Precautions:
1.Response time will be extremely delayed at lower temperature than the operating temperature range and on the other hand at higher
temperature LCD may turn black at temperature above its operational range. However those phenomena do not mean malfunction or out of order with the LCD. The LCD will revert to normal operation once the temperature returns to the recommended temperature range for normal operation.
2.Never use the LCD under abnormal conditions of high temperature and high humidity.