36.6 Inch Bar Type Tft Display 1920x290 Ips Viewing Angle Lvds Interface 51 Pins
General Description:
The backlight of DV366FBM-N10 adopts WLED light-emitting side-entry light source with 50K hours of life without backlight driver. The LVDS (2 ch, 8-bit) signal interface is used, with a total of 51 pins, using terminal connections and a drive screen voltage of 12.0V (Typ.). It has a typical vertical refresh rate of Fv of 60Hz.
Specifications:
Parameter | Specification | Unit | Remarks |
Active area | 919.3(H) × 138.85 (V) | mm | |
Number of pixels | 1920(H) × 290(V) | pixels | |
Pixel pitch | 159.6(H) × 478.8(V) | um | |
Pixel arrangement | Pixels RGB Vertical stripe | ||
Display colors | 16.7M | colors | 8bits True |
Display mode | Normally Black | ||
Dimensional outline | 960(H)*174.35(V)*16.9(B) | mm | Detail refer to drawing |
Weight | 3260 | g | |
Power Consumption | 5.4 | Watt | Typ. |
Bezel width (L/R/U/D) | 17.85/17.85/15.25/15.25 | mm | |
Surface Treatment | Haze 1% | ||
Back-light | Down edge side, 2- LED Light bar | ||
Possible display type | Landscape and Portrait Enabled |
Absolute Maximum Ratings:
Parameter | Symbol | Min. | Max. | Unit | Remark |
Power Supply Voltage | VDD | VSS-0.3 | 13.5 | V | Ta = 25 ℃ |
Operating Temperature | TOP | 0 | +50 | ℃ |
|
Storage Temperature |
TSUR |
-20 | +60 | ℃ | |
TST |
-20 | +60 | ℃ | ||
Operating Ambient Humidity |
Hop | 10 | 80 | %RH | |
Storage Humidity | Hst | 10 | 80 | %RH |
Electrical Specifications:
Parameter | Symbol | Values | Unit | |||
Min | Typ | Max | ||||
Power Supply Input Voltage | VDD | 10.8 | 12 | 13.2 | Vdc | |
Power Supply Ripple Voltage | VRP | - | - | 300 | mV | |
Power Supply Current | IDD | - | 450 | 600 | mA | |
Power Consumption | PDD | - | 5.4 | 8 | Watt | |
Rush current | IRUSH | - | 3.0 | A | ||
LVDS Interface |
Differential Input High Threshold Voltage | VLVTH | +100 |
- |
+300 | mV |
Differential Input Low Threshold Voltage |
VLVTL | -300 |
- |
-100 | mV | |
Input Differential Voltage | | VID | | 200 | - | 600 | mV | |
Common Input Voltage |
VLVC |
0.6 |
1.2 |
2.4- |VID |/2 |
V |
|
CMOS Interface |
Input High Threshold Voltage | VIH | 2.7 |
- |
3.3 | |
Input Low Threshold Voltage |
VIL | 0 |
- |
0.6 | V |
Interface Connection:
Pin No | Symbol | Description | Pin No | Symbol | Description |
1 | GND | Ground | 16 | ERX2- | Even pixel Negative LVDS differential data input. |
2 | SCL | I2C Clock | 17 | ERX2+ | Even pixel Negative LVDS differential data input. |
3 | SDA | I2C Data | 18 | GND | Ground |
4 | NC | No Connection | 19 | ECLK- | Even pixel Negative LVDS differential clock input. |
5 | NC | No Connection | 20 | ECLK+ | Even pixel Negative LVDS differential clock input. |
6 | NC | No Connection | 21 | GND | Ground |
7 | SELLVDS | LVDS data format selection | 22 | ERX3- | Even pixel Negative LVDS differential data input. |
8 | NC | No Connection | 23 | ERX3+ | Even pixel Negative LVDS differential data input. |
9 | NC | No Connection | 24 | NC | No Connection |
10 | NC | No Connection | 25 | NC | No Connection |
11 | GND | Ground | 26 | GND | Ground |
12 | ERX0- |
Even pixel Negative LVDS diffe rential data input. |
27 | GND | Ground |
13 | ERX0+ | Even pixel Negative LVDS differential data input. | 28 | ORX0- | Odd pixel Negative LVDS differential data input. |
14 | ERX1- | Even pixel Negative LVDS differential data input. | 29 | ORX0+ | Odd pixel Negative LVDS differential data input. |
15 | ERX1+ | Even pixel Negative LVDS differential data input. | 30 | ORX1- | Odd pixel Negative LVDS differential data input. |
31 | ORX1+ | Odd pixel Negative LVDS differential data input. | 42 | GND | Ground |
32 | ORX2- | Odd pixel Negative LVDS differential data input. | 43 | GND | Ground |
33 | ORX2+ | Odd pixel Negative LVDS differential data input. | 44 | GND | Ground |
34 | GND | Ground | 45 | GND | Ground |
35 | OCLK- | Odd pixel Negative LVDS differential clock input. | 46 | GND | Ground |
36 | OCLK+ | Odd pixel Negative LVDS differential clock input. | 47 | NC | No Connection |
37 | GND | Ground | 48 | VCC | +12V |
38 | ORX3- | Odd pixel Negative LVDS differential data input. | 49 | VCC | +12V |
39 | ORX3+ | Odd pixel Negative LVDS differential data input. | 50 | VCC | +12V |
40 | NC | No Connection | 51 | VCC | +12V |
41 | NC | No Connection |
Optical Specification:
Parameter | Symbol | Condition | Min | Typ | Max | Unit | ||
Viewing Angle |
Horizontal |
Θ3 |
CR > 10 |
80 | 89 | - | Deg. | |
Θ9 | 80 | 89 | - | Deg. | ||||
Vertical |
Θ12 | 80 | 89 | - | Deg. | |||
Θ6 | 80 | 89 | - | Deg. | ||||
Brightness | Lv |
Θ=0° (Center) Normal Viewing Angle |
560 | 700 | - | nit | ||
Contrast ratio | CR | 800:1 | 1200:1 | - | ||||
White Iuminance uniformity | ΔY | 75 |
- |
- |
% | |||
Reproduction of color |
White |
Wx |
TYP. - 0.03 |
0.289 |
TYP. + 0.03 |
|||
Wy |
0.332 | |||||||
Red |
Rx |
0.650 | ||||||
Ry |
0.341 | |||||||
Green |
Gx |
0.304 | ||||||
Gy |
0.625 | |||||||
Blue |
Bx |
0.148 | ||||||
By |
0.071 | |||||||
Color Gamut | 70 | 72 | - | % | ||||
Response Time | G to G | Tg | - | 8 | 10 | ms |
Handling Precautions:
1.Do not leave the module operation or storage in Strong light . Strong light exposure causes degradation of polarizer and color filter.
2.Since a module is composed of electronic circuits, it is not strong to electrostatic discharge. Make certain that treatment persons are connected to ground through wrist band etc.