- eliminate the typical inconvenient requirements of removing an existing day scope from a weapon, or the need to replace the day scope with a dedicated thermal sight.
- mount in front of existing day scopes, converting riflescopes into thermal devices in seconds, and without tools. All units are waterproof, recoil-tested and bore-sighted to tolerances of less than 1 MOA, so no re-zeroing is required by the operator.
- allow users to maintain consistent eye relief and shooting position. No re-training is necessary, because the user isn’t required to learn how to operate a totally new device.
Find the features that are right for you :
▼ Simple and Quick conversion of daytime scope to Thermal
▼ Mounts in front of any daytime scope; no re-zeroing required
▼ Powered by 2X 3V CR123A lithium battery
▼ Quick-Release Mount
Thermal Imager Scope NightSeer 350 Series Technical Data Sheet | |
Model | NS350-C |
Microbolometer | |
Type | Uncooled |
Resolution, pixels | 384×288 |
Frame Rate, Hz | 50 |
Pixel size, um | 17 |
NETD | less than 50mk |
Optical Characteristics | |
Objective Lens | 50mm, F/1.1 |
Magnification, X | 1 |
Zoom | 2x/PIP/4x |
Eye Relief, mm | 24mm |
Dioptre Adjustment, D | / |
FOV | 7.4°×5.6° |
Close-up range,m | 5 |
Display | |
Type | OLED |
Resolution, pixel | 1024×768 |
Power Supply | |
Battery Type | 2XCR123 |
Power Supply | 3.6~7.2 |
External Power Supply | 5v USB |
Operation Time on a battery set(standard version),h | 5 |
Operation Time on external battery pack(standard version),h(13000mAh) | 44 |
Video recorder(optional) | |
Video/Photo format | avi/jpg |
Built-in memory(optional) | 32G |
Wifi Channel(optional) | |
Frequency | 2.4 |
Reception range,m | 15 |
Physical Parameters | |
Degree of Protection | IP67 |
Operation Temperature | —25°C~+50°C |
Storage Temperature | —40°C~+70°C |
Shock and Vibration | 1000g/ms |
MTBF | More than 800h |
Weight without batteries,g | 425 |
Dimension, mm | 167×65×67 |
We understand that, in some cases, lives may depend on the performance of our products, that is why every unit that leaves our facility must pass tough quality control standards testing.
It is our mission to continue to design, build, test and ship the very best optoelectronic devices on the market.