High Resolution Optoelectronic Components, 7.93*5.99mm Full Color Micro OLED
Micro OLED embeds low-latency video processing capabilities and manages look-up tables, a key to guaranteeing high-quality images. It is based on MICROOLED’s proprietary OLED-on-CMOS technology featuring very high resolution at an extremely small footprint, low power consumption, and excellent video picture quality.
MDP03CP | |
Resolution |
Standard XGA resolution: 1024(H) x 768(V) 20 extra lines and 20 extra columns for image position adjustment |
Number of pixels | 1024 x 768 x 4 sub-pixels active matrix = 3.2M dots |
Pixel arrangement | Square pixel arrangement |
Pixel pitch | 7.6µm x 7.6µm (sub-pixels 3.8µmx3.8µm) |
Active area | 7.93mm x 5.99mm (0.39’’ diagonal) |
Luminance |
MDP03CPFC: up to 250cd/m²; 73fL MDP03CPWF: up to 400cd/m²; 117fL |
White color balance |
CIExy (0.305, 0.315) standard white @ 200 Cd/m2 (Other coordinates available on request) |
Video interface |
Standard digital video interface (RGB 4:4:4, YCbCr 4:2:2) Compatible with Gray-encoded RGB 4:4:4 video data |
Latency | Minimal, constant latency guaranteed by design (less than 80uS @ 60Hz frame rate/63.5Mhz pixel clock). |
Frame rate | Typically 60 frames per second |
Control interface | I²C |
Non volatile memory | Embedded color correction and product traceability data |
Video processing | Embedded video processing for a perfect image quality and straightforward system integration |
Temperature sensor | Embedded digital temperature sensor |
Operating voltage |
Two modes available: - Single supply mode = 3.3V – Li-Ion battery compatible (lowest cost) - Dual supply mode = 3.3V – Li-Ion battery compatible and 1.8V (lowest power consumption) |
Voltage regulator | Embedded voltage regulators |
Cathode voltage | Embedded programmable negative cathode voltage generator |
Power consumption | ~200mW in typical video mode |
Operating temperature range | MDP03CP: -40°C to 70°C |
Storage temperature | MDP03CP: -40°C to 70°C |
SALES & SERVICE
We understand that as a manufacturer it is important to work tightly with our distributors to support customers from different regions. We try our best to make sure all customers can get proper training of our device and good after-sell service when any kind of failure occurs.
QUALITY CONTROL
We understand that, in some cases, lives may depend on the performance of our products, that is why every unit that leaves our facility must pass tough quality control standards testing.
It is our mission to continue to design, build, test and ship the very best optoeletronics devices on the market.