The toilet drain mouth seal rubber ring, anti-odour waterproof seal rubber gasket.
Installation steps of toilet seal ring:
Be sure to close the toilet inlet valve.You can close the water valve at the toilet, but you may also need to go to the plumbing or basement to close the water.
2. Flush the toilet once or twice, flush the water from the water tank and the potty.
Use a sponge to soak up all the remaining water in the tank and the potty.
4. Remove the nut cover that holds the bedpan base on the ground.
5. Unscrew the nut.You may need to use lubricants and pliers.
Disconnect the water supply.
Gently move the toilet back and forth, loosen the sealing ring and the filler.Take care of the bedpan, not the water tank.If you hold the water tank, you may break or break the connection between the tank and the basin.
Remove two old seal rings on the joint.Go to part 2.Part 2:1. Open the new wax seal and make it round to the side, and set it on the flange of the ground, so that it is right above the opening.Make sure two screws are in place.
2. Lift the toilet, cover the flange and sealing ring, and keep the toilet level as far as possible.
Sit on the toilet and help seal the new seal.
4. Make sure the potty stays level.
Reload the nut you just removed.Tighten the nuts with your hand to avoid cracking the bottom of the toilet.
Reconnect the water supply.
7. Open the water valve to hold the water tank.You can open the water valve in half and water the tank with lower water pressure.This method will hold water longer.
Flush and check for leaks.
9. Type silicone gel between the floor and the bedpan as needed.
Wash your hands with antiseptic soap
Name: | The toilet seal rubber ring. |
Type: | S-430 |
Brand: | San-Tide |
Origin: | Chian xiamen |
Shape: | O ring |
Material: | rubber |
Shape: | Type O |
Performance: | seal |
Foreign trade: | is |
Color: | Black |
Usage: | Installed directly |
Activity type: | The toilet sewage |
Flushing control mode: | Hand press type |
Quality level: | High quality rubber |
Scope of application: | toilet |
Rubber flange features:
1. Load the surface PVC drain pipe from the inside of the triple seal to prevent the odor and prevent leakage.
2. The flanges are adjustable, the underground blowdown pipe is lower than the ground, and it does not affect the sealing, which is suitable for all kinds of toilets.
3. Easy to install, directly load into the drain port, the toilet will be put on a pressure, can be reused.
4.Rapid drainage.
5. Pure rubber material anti-aging, durable and effective anti-leakage and anti-stink.