^{The track laying of low-voltage track electric flat car needs insulation. If it is not handled properly, it will lead to voltage instability or drop, affect the running speed of track flat car, and even fail to run; Secondly, the former requires the installation design of copper wire or conductor rail. The track length is greater than 70m, and the number of transformers needs to be increased to make up for the track voltage drop.}

^{At present, low-voltage rail flat car is a powerful means of transportation, which solves the transportation difficulties in the enterprise. It not only greatly saves human resource management, assets and capital investment, but also reduces the risk index value in production and manufacturing, saving time and labor, so as to improve the production efficiency and create greater economic benefits for the enterprise.}

Power Motorized Rail Transfer Cart , 35 Tons Low Voltage Road Rail Trailer

^{The electric flat car with low-voltage track and bottom pressure track is divided into two types: two-phase power supply system and three-phase power supply system.}

^{When the power supply is connected, the key is to reduce the working voltage to 36 V, rely on the road of the cabinet, then fly to the conductor rail, and then fly to the transformer. According to the vehicle interceptor, guide rail slider and other mechanical equipment, after the working voltage rises,}

^{Machinery and equipment arriving at the vehicle interception cabinet.}

^{The installation requirements of insulation layer ground rail for electric flat car of this model and specification are different from that of general ground rail.}

^{The running ground rails of electric flat car need the edge layer and out of limit resistance between each other.}

^{According to the requirements of the edge layer of the ground rail, it is generally necessary to soak the edge layer with sulfur powder as the anchor screw, and then add the buffer block of the plastic protective layer of the edge layer under the track pressing plate,}

^{This can better expand the resistance value of the grounding wire in the middle of the ground rail.}

^{Track wheel set must be installed during calibration, and the error of parallel line shall be within ± 3mm.}