WIZ820io Original electronic components Networking Modules W5200 ioPLATFORM MODULE integrated circuits
1. Feature
Supports 10/100 Base TX
Supports half/full duplex operation
Supports auto-negotiation and auto cross-over detection
IEEE 802.3/802.3u Compliance
Supports high speed SPI Interface (SPI mode 0, 3)
Operates 3.3V with 5V I/O signal tolerance
Supports network status indicator LEDs
Includes Hardware Internet protocols: TCP, IPv4, UDP, ICMP, ARP, PPPoE, IGMP
Includes Hardware Ethernet protocols: DLC, MAC
Supports 8 independent connections simultaneously
Supports Power down mode
Supports Wake On LAN
Supports Socket API for easy application programming
Interfaces with two 2.54mm pitch 1 x 6 header pin
Very small form factor: 23mm x 25mm (PCB size)
2.Process of using general SPI Master device
1. Configure Input/Output direction on SPI Master Device pins.
2. Configure nSCS as ‘High’ on inactive
3. Write target address for transmission on SPDR register (SPI Data Register).
4. Write OP code and data length for transmission on SPDR register.
5. Write desired data for transmission on SPDR register.
6. Configure nSCS as ‘Low’ (data transfer start)
7. Wait for reception complete
8. If all data transmission ends, configure nSCS as ‘High’
Product Category: | Networking Modules |
Network Modules | |
W5200 | |
80 MHz | |
10 Mb/s, 100 Mb/s | |
1 Port | |
Ethernet, SPI | |
3.3 V | |
3.3 V | |
- 40 C | |
+ 85 C | |
Product Type: | Networking Modules |
40 | |
Subcategory: | Ethernet & Communication Modules |
Unit Weight: | 0.711955 oz |