Sparkle Tile Listello Aluminium U Shape Trim Edge Gold Decorative Metal Corner

Application

10mm x 10mm Sparkle Listello.

Length: 1.0Lm

This versatile Listello can be used horizontally or vertically as a feature strip in wall applications.

Create an extra special look to your tiling with these fantastic coloured Sparkle Listellos.

It can also be used as a divider, crack inducer or even as a decorative feature as well as a Listello strip to break up an expanse of mosaic or standard tiling.

Feature

There are many reasons to choose aluminium for interior fittings. This extraordinary material has an array of properties that have made it a key ally of interior designers and architects. It is lightweight, visually appealing and hard-wearing - with its glossy or satin finishes, it fits in perfectly in elegant spaces while being high-performing at the same time. We offers a broad range of aluminium listello tile trims to provide functional solutions to every home building and improvement requirement.

Use

1. Choose shape and profile according to tile thickness.

2. Apply thin set mortar according to manufacturer’s directions to the area where profile is to be placed, using the appropriate size U notch trowel.

2a. For edging and outside wall corners using L-Shape or R-Round Bullnose, finish tiling one wall first, then trowel thin set mortar over corner areas of second wall.

2b. For the U-Shape Reducer, fill the hollow space beneath the sloped section of profile with thin set mortar before setting the trim.

3. Press the perforated anchoring leg of the profile into the mortar until mortar fills the circle cutouts. Then align trim with tile edge making sure the tile is flush against lower edge of trim face to ensure a uniform grout joint space between trim and tile.

4. Trowel additional thin set mortar evenly over the perforated anchoring leg completely covering the circle cutouts to ensure full coverage and support of the tile edges. The anchor leg should be partially buried in the sealant.

5. Ensure the tile is flush with top of profile or slightly lower. The profile should not be higher than the tiled surface, but rather up to approx. 1/32” (1 mm) lower.

6. After the tiles and profile have set, fill the grout joint completely with grout.

7. Gently wipe off any excess grout or thin set mortar immediately.

Specification