Truck Propeller Rubber DAYUN Drive Shaft Center Support Bearing

Truck Propeller Shaft Drive rubber Support Center Bearing for DAYUN Chinese factory discount price high quality

The solution to repair the failure of the drive shaft
Tighten the front wheel of the car with mats, jack up the middle and rear drive axles on one side of the car; start the engine, put on high gear, and observe the vibration of the drive shaft. During the inspection, notice that when the speed drops, if the shimmy increases significantly, it indicates that the drive shaft is bent or the flange is skewed.

The bending of the transmission shaft is the bending of the shaft tube, most of which are caused by the overload of the car. Due to overloading and overhanging of coal-carrying vehicles, the drive shafts are bent and broken. If some trucks and trailers transport more than 60 tons of coal, the drive shaft is seriously damaged due to overload and overhang. Although the intermediate support of the transmission shaft was strengthened and the strength of the flange fork was strengthened, the failure of fracture and damage still occurred.

After replacing the drive shaft components and straightening, check the balance, and the unbalance should meet the standard requirements. The technical condition of the universal joint fork and the transmission shaft hanger should also be checked in detail. If the installation fails to meet the requirements, the cross shaft and roller damage will cause looseness and vibration, and the transmission shaft will also lose balance.

OUR SERVICE
1. Production according to customer's drawings and needs
2. Small orders is ok
3. Reasonable price
4. High Product Performance
5. Prompt Delivery
6. Good after-sales services
7. Precise casting

Image description: