Refractory Material Crushing And Grinding Equipment Single Roller Vibration Ball

Introduction of Single Roller Vibration Ball Mill Grinding Equipment for Refractory Material:

The Single Roller Vibration Ball Mill Grinding Equipment for Refractory Material is a new type of high efficiency and energy saving grinding equipment. It has obvious advantages over traditional rotary mill in grinding fine powder and ultrafine powder (efficiency increased 2-5 times, energy consumption reduced 20-30%). This kind of machine has the advantages of large vibration intensity, high grinding efficiency, less power consumption, low noise, compact structure, easy installation and maintenance. The machine can be widely used in mineral processing, building materials, grinding materials, powder metallurgy, electric power, ceramics, refractory, magnetic materials, chemical, food and other industries, is an ideal replacement products of ball mill.

Application of Single Roller Vibration Ball Mill Grinding Equipment for Refractory Material:

The single roller vibrating mill has a wide range of application. It can be widely used in grinding materials of powder metallurgy, electric, ceramic, mineral, building materials, refractory, magnetic material, Chemical, food, and other industries.

Structure of Single Roller Vibration Ball Mill Grinding Equipment for Refractory Material:

The energy-saving single cylinder vibration mill for grinding powder is mainly composed of vibrating motor, body, chassis, grinding cylinder, liner, grinding medium and elastic support etc.

1. Grinding cylinder housing: It is the working body of the vibration mill, which is used to hold the grinding medium and the grinding material. The grinding cylinder housing is composed of a grinding cylinder, and the grinding cylinder is equipped with a wear-resistant lining cylinder. When the lining cylinder is ground and damaged, it can be removed and replaced.

2. Chassis: lifting the body by elastic support.

3. Vibrating motor: providing energy for the vibration grinding of the mill. The vibrating motor has two sets of eccentric blocks, and the eccentric blocks on both sides rotate in the same direction, so that the required exciting force tick marks are aligned with the datum line of the shaft end.

4. Elastic support: installed on four fulcrums, each fulcrum has two springs, the main function is to make the mill body in an elastic state, and basically isolate the vibration impact on the base when the body vibrates, thereby reducing the dynamic load transferred by the mill to the foundation. In order to keep the mill in good working condition, the gasket can be adjusted under the spring support, which is used to solve the installation problem of the levelness of the grinding body (cylinder). Each set of springs must ensure the coaxiality of the upper and lower contact surfaces of the spring during the installation process, and the tolerance shall not exceed 2mm.

5. Grinding medium: it is the grinding main body of the mill, which is used for impact grinding of materials.

6. Lining cylinder: it is closely attached to the inner wall of the grinding cylinder to protect the grinding cylinder. When the material is vibrated in the grinding cylinder, the inner wall of the grinding cylinder is also greatly worn at the same time, and the liner which is easy to replace in the grinding cylinder can improve the service life of the whole machine.

Advantages of Single Roller Vibration Ball Mill Grinding Equipment for Refractory Material:
1. Closed milling system, no dust emission, no pollution.

2. Easy installment and maintenance.
3. Low energy consumption and low production cost.
4. Simple production process and high efficiency.
5. Perfect electrical control function, very convenient for switching system.

Technical Parameters of Single Roller Vibration Ball Mill Grinding Equipment for Refractory Material:

Contact: Ms. Magie

E-mail: sale@aarealmachine.com

magiecn@gmail.com

WhatsApp/WeChat: 0086-15637361027

Website: https://www.aarealmachine.com