003840-1 Cnc Waterjet Machine Spare Parts 60 ksi On/Off Valve Closed Air Actuator Assembly water jet cutter parts

How can the incidence of waterjet failure be reduced?

The quality of the water jet is strictly inspected when it leaves the factory. In addition to human factors, the quality of the waterjet is subject to strict inspections. In addition to human factors, it is somewhat affected by the quality of high-pressure cylinders, check valve plugs and other components. In other words, if the quality of these parts is better and the service life is longer, then the incidence of waterjet failures can also be reduced.

For cutting materials with different thicknesses, water jets should be equipped with different cutting heads. Tests have shown that when cutting materials with a thicknessess than 2.5, the output of using medium or large cutting heads is not high. If necessary, small parameter combinations can be used and multi-head cutting can be considered to increase production.

Since waterjet cutting has strict regulations on the size of the cutting air gap, in order to avoid cutting the air gap greater than 0.5mm, the surface is rough when cutting the lower layer; when stacking cutting, keep the sheets neatly stacked together to achieve this a little. In order to reduce surface fogging, underwater cutting can be considered, because underwater cutting can reduce the surface or upper edge fogging caused by the sanding waterjet cutting process, and greatly reduce the noise during cutting, and at the same time make the working environment more tidy and orderly .

003840-1 Cnc Waterjet Machine Spare Parts 60 ksi On/Off Valve Closed Air Actuator Assembly water jet cutter parts:

Our company:

Shandong WAMI CNC Technology Co., Ltd. is located in the High-tech Development Zone of Jinan City, Shandong Province. It is a high-tech enterprise specializing in the research and development, production, sales and technical services of CNC ultra-high pressure water jet technology application products.The main product of the company is "Ultra-high pressure CNC water cutting machine", which is the world's new cold cutting technology and advanced manufacturing equipment.It combines high-tech products in many fields such as organic-electric integration, ultra-high pressure water jet technology and numerical control automation, automatic detection and compensation, computer-aided design and manufacturing, and robot applications. It is a world-class high-tech product.The pressure range of the three-way pressure regulating valve is very large, and the use range of the three-way pressure regulating valve can be used normally from 80 to 400 MPa, and can even be used normally at higher pressures.

The basic principle and structure of the direct-drive rotating electric machine is to adopt the permanent magnet method, and design a special disk motor. At the same time, it makes full use of the space at both ends of the outer rotor type structure. The stator and the outer rotor type of the two disk motor are combined. The stator of the structure is fixed, and the rotor discs of the two disk-surface motors and the rotor barrel of the outer rotor type structure form a three-dimensional closed outer rotor. The direct drive linear motor DDL2 consists of a basic mover (primary) and a stator (secondary) two parts structure. The stator part is mainly composed of permanent magnets and stainless steel sleeves. The permanent magnets are magnetized in the axial direction. The mover Part of it is composed of three-phase armature winding, winding frame and machine. The winding adopts the form of hollow pie-type wire, which is directly wound in the frame slot, with high slot full rate, no ends, high copper utilization rate, and low copper consumption. The motor has a better energy-saving effect. A 22KW direct drive high-pressure pump and a 37KW booster pump have similar cutting speeds.