Sludge dewatering machine belongs to the screw press, it's clog-free and can reduce the

sedimentation tank and sludge thickening tank, saving the cost of sewage plant construction.

Sludge dewatering machine using screw and the moving rings to clean itself as clog-free

structure, and controlled by the PLC automatically, it's a new technology that can replace the

traditional filter press like belt press and frame press, the screw speed is very low, so it cost

low power and water consumption in contrast to the centrifuge, it is a cutting edge sludge

dewatering machine.

The initial section of dewatering drum is the Thickening Zone, where the solid-liquid

separating process takes place and where the filtrate will also be discharged. The pitch of the

screw and the gaps between the rings decrease at the end of dewatering drum, hence

increasing its internal pressure. At the end, the End Plate further increases the pressure, so

as to discharge dry sludge cake.

Characteristic

♦It is not easy to be blocked

With self-cleaning function. There is no need to prevent the filter clogging and cleaning,

reduce the amount of water rinse, and reduce the burden of internal circulation.

♦Low speed operation

1. Rotary shaft speed about 2 to 3 r / min, low power consumption.

2. Less failure, small noise, and safe operation.

♦ Simple operation

1. Through the cabinet interlocked with the feeding pump, dosing pump, to achieve 24 hours

of continuous unmanned operation.

2. Routine maintenance time is short, maintenance is simple.

♦ Long service life

1. The body is almost all stainless steel, to maximize the service life.

2. Replacement parts only screw shaft and swimming ring, the use of long cycle.

Technical parameters