Self Aligning Pipe Welding Rotator With Hand Box And Foot Pedal Control,20T Pipe Welding Rotator More products pics.pdf

1. Including : One set drive / One set idler / Electric control system

2. Voltage : 220V ~ 600V all available.

3. Control Way : Remote Control Box / Foot Pedal

4. Warranty: One Year by Wuxi Success Machinery Equipment Co., Ltd

5. Package Way : Wooden Case

Description of self aligning pipe welding rotator

1. It will adjust the tank diameters automatically.

2. Wireless control is more convenient than remote control cable.

3. Working range can be designed according to your tank diameter.

4. Low noise transmission and stable turning roller during working.

20T Pipe Welding Rotator / Pipe Turning Rolls Technical Data

Note: The lubricating oil isn't oiled into the machine at shipping, the users must oil assigned lubricating oil, and then begin to use. Capacity from 5T ~ 1000T.

Pipe Welding Rotator Applications

1. The drive roller and idle roller must be put the foundation in same horizon.

2. Two sets roller must be parallel to put, the ground horizontal plane must even.
3. The worm wheel decelerator of the machine adopts lubricating oil, other gears and bearings adopt grease lubrication, periodic change.

Pipe Welding Rotator Details Control system and Brand

1. Inverter is from Taida/Yaskawa Brand

2. Motor is from CE Invertek Brand

3. Reducer is from Cable. Made in China.

4. Electric system is from Schneider

Attention please

1. When finished installation, check whether tight firmware of each port loosens to move the phenomenon or not, if have, please tighten them immediately.
2. Before the usage check the machine and clear some bar the on board ,the rubber roller can not get in touch with oil, and keep off the heat possibly.These will prevent gum the gum roller to aging.

3. We will supply you all the detail work manul for your reference.

DO NOT HESITATE ! JUST SEND US YOUR INQUIRY BELOW.