6.5 Liter 150 Watt Ultrasonic Carb Cleaner Machine With 300W Heater

How Whale Cleen sonic Ultrasonic Carb Cleaner Works?

Ultrasonic cleaning works by producing sound waves in liquids. The waves consist of both high- and low-pressure fronts. The low-pressure fronts are small enough to cause bubbles to form. The high-pressure fronts cause the bubbles to collapse. The expanding and collapsing bubbles loosen contaminants on the part surface and the chemical cleaners either dissolve or segregate the free contaminants. As with sound waves in air, ultrasonic sound waves can be varied by both frequency (pitch) and amplitude (power). Higher frequencies will produce smaller bubbles and lower frequencies will produce larger bubbles. Larger bubbles will typically dislodge large particles and smaller bubbles small particles. Typical industrial systems are either 25 KHz or 40 KHz, which can handle the particle sizes in the range of normal automotive cleaning. Ultrasonic cleaning systems with a much higher frequency are used in the computer industry where tiny particles need to be removed.

How To Clean Carburetor With Wahle Cleen Ultrasonic Carb Cleaner Machine

1. Fill the tank with water and cleaning solution to the fill line (Approx. 5% solution).
2. Set temperature controller to 50°C
3. With the cleaning solution in the tank, turn on the ultrasonic power for 5 minutes to de-gas the solution.
4. Clean carburetors from 15 to 30 minutes (15 minutes for lighter cleaning, 30 minutes for heavily soiled carburetors
5. Rinse carburetors with water after cleaning.

Data Sheet Of z-s031:

Customer's Feedback Of Carb Cleaning:

FAQ:

1. What are the advantages of ultrasound over traditional cleaning methods?

minimize the use of manual labor

make cleaning and degreasing without the use of organic solvents

clean hard to reach areas of products and remove all types of dirt

shorten the processes such as extraction, dispersion, purification, chemical reactions

eliminates costly mechanical and chemical cleaning of heat exchangers

2. What frequency is better for my parts?

Frequency is suggested based on pollutants in the objects.

28kHz frequency is stronger, better for car/motor/truck/vessel parts clean(oils, grease,rust,pastes, etc. )

40kHz is better for pcb boards, electronic parts, etc.

Higher precision goods, higher frequency.