this machine make scrap copper to 8-17mm copper

The line is specially used to produce high conductivity oxygen free copper rod. When the mould clamping wheel is changed, it can also produce other specifications of copper rod, copper tube and other cross-section products. The casting specification is copper rod Φ8-20mm, and the daily production capacity is about 6t. The melting furnace adopts one set 300KG / 80kW electric furnace, and the holding furnace adopts one set 80kW electric furnace. The annual output of two connected updraft continuous casting unit is 2000 tons / year. The unit is driven by imported servo motor and loaded with advanced pitch control system in China. Users can directly input pitch length to meet the special requirements of casting process

Main technical parameters:

Two connected furnace

Rated total power of melting furnace 80KW

Rated power of holding furnace 80KW

Number of continuous casting heads 4

Copper rod doameter: Ф8-20mm

Upper leading speed 560-2400mm/min

Working hours per year 7200h

Level tracking accuracy ±2mm

Winding specificati φ700mm×φ1600mm×800mm

Power consumption rate of molten copper ＜345kwh/ton

Power factor 0.95-1

Cooling water pressure 0.25-0.3mpa

Take up form: frequency conversion synchronous take up (8-12mm with automatic cable arrangement function)

Take up drive mode: reducer motor drive

Up lead drive mode: AC servo motor drive, the transmission chain adopts the synchronous toothed belt drive without clearance

Operation interface: data display and servo motor are controlled by touch screen display

The caster adopts four columns, the motor adopts Yaskawa servo motor of Japan, Mitsubishi PLC programming control, color touch screen operation display, and uses domestic advanced pitch control program to drive the servo motor, so that the system has a wide and convenient speed regulation range, and the precise operation mode can make the control response accuracy reach 0.01s, and the reducer adopts imported high-precision reducer without gap. It can meet the special requirements of updraft continuous casting track. The take-up system adopts advanced synchronous tracking system, tension sensor and copper rod arranged in order, and the take-up amount is more than 3t. The main electrical equipment is Schneider t electric, and the silicon steel sheet is imported from Japan. The products are superior to the domestic similar products.