Non Woven Fabric Valved Fold Flat Mask KN95 , Filtered Respirator Mask

1 . Descriptions

The Dust Mask is light and comfortable. The internal nosepiece is made of velvet/sponge double-layer. There are no exposed metal components; the external nosepiece used to adjust the mask on the face is metal coated. Structure and materials are long lasting and avoid the collapse in humid environments.

2 . Material of each layer

1st layer : Protective pp spun-bonded non-woven

2nd layer : Active carbon filter(MX-3006)

3rd layde : FFP1 melt blown filter(have filter efficiency level of 80%)

4th layer : Shaped needle punched cotton

3 . Directions for use

• The mask is for single use only.
• The mask should not be removed from its packaging until its required for use.
• Use the respirator in accordance with applicable health and safety regulations.
• Fit the respirator and check leak-tightness before entering the contaminated area.
• Wear the respirator for the whole duration of exposure to contaminants.It should not be used for more than 8 hours continuously and should be discarded after use.
• Transport and stockage of unused masks should be such that the product is not stored in direct sunlight and in frost free conditions,not in contact with solvents and cannot be damaged by physical contact with hard surfaces/items.
• As required by European Health and Safety requirements,the user is advised that when the mask is in contact with the wearer’s skin,it may cause allergic reaction to susceptible individuals.If this is the case,leave the hazard area,remove the mask and seek doctor’s advice.

​

4. Discard and replace the mask if:

• The mask is removed whilst in the contaminated area.
• Clogging of the respirator causes breathing difficulties.
• The mask becomes damaged.
• For respirators protecting against vapours,the smell of vapours present becomes derectable.
• When the respirator is not used,the sliding elastic bands allow to hang up the mask around the neck

5. More pictures