Premium Material:PTFE fiberglass fabric tape features 3/4 IN wide, 30 ft length and 0.18 mm thickness, more durable than 0.15 mm thickness tape. The temperature resistance is up to 500 °F (280 °C).

Excellent Quality:Strong stickness,High temperature resistance,Winding tight. The fabric tape features good insulation and wear resistance, it can meet your different application and work longer time.

Easy to use:Peel off the adhesive tape from the roll and stick the tape directly on place. Upper the wire for vacuum sealers, under the wire for impulse sealers.

Multipurpose:Wide apply for heat sealing, like Impulse Sealer, high-speed sealing machine, food packaging, hot melt machine, motor, wire and cable insulation protection and so on.

The surface is smooth and it is not easy to adhere to any substance. Easy to clean all kinds of oil stains, or other attachments on the surface.
Chemical resistance, corrosion resistance to strong acid, alkali, aqua regia and various organic solvents.
Just peel tape from the roll and place on the correct area. Over the wire for vacuum sealers, under the wire for impulse sealers.
Replaces deteriorated or burnt-out tape, which is a crucial barrier between the heating element and the bag.
Long Service Time Temperature -70°C to 260 °C,Fits virtually all Food-Saver, Weston, Cabella's, Nesco and Seal-A-Meal vacuum sealers.

Application:
1.Insulation of wires, cables and coils (for Type H electrical insulation)
2.Feeding lining material
3.Sliding material for rails
4.Isolation material for heat sealing
5.Prevent adhesion of glue and stickers
6.For the removal of wood molds and plastic forming dies
7.Paper feeding tape for fax machines
8.Copier rails
9.Gasket lining material
10.Gaskets that are exposed to corrosive chemicals
11.Lining of various mechanical sliding surface
12. etc

Usage Method:
1) Simply remove the tape on your current heating element (make sure to get the residue from the old tape off).
2) Cut your new replacement tape to the correct size.
3) Remove the yellow backing from the tape and place over the heating element (under the element if using for an impulse sealer). Smooth out the tape with your finger as you go, to ensure a good bond.