ZT1808 Large Frame Anti-Fog And Anti-Scratch Single Lens Diving Mask

This is a diving mirror with ergonomic design concept, very fit to the face, comfortable to wear, can be used for scuba diving, free diving, snorkeling and other scenarios;

This is a diving mirror with ergonomic design concept, very fit to the face, comfortable to wear, can be used for scuba diving, free diving, snorkeling and other scenarios;

Descriptions

•Single-piece high permeability toughened glass lens, better light transmittance, no deformation of the picture

•Ergonomic design, suitable for all types of face, tight, comfortable and watertight
•Select material, scratch - proof, anti - fall, the pursuit of better user experience
•Toughened glass lens, wider field of vision, high-definition light transmission

Specifications

Maintenance:
Rinse the whole mirror with fresh water after use, and clean the salt on the mirror, then dry it and place it in the mirror box.

Operation use:

(1) Adjust the fixed band to the appropriate tightness before wearing the face mirror.

(2) First put the mirror on the right position of the face.

(3) Use the nose to inhale the mirror adsorption on the face.

(4) Adjust the left and right ends of the fixed band to appropriate tightness by quick adjustment buckle, and the fixed band of the mirror should be above the ear (tightness should not be too tight).

(5) Hair or head coverings (no hair or head coverings should be pressed on the skirt of the mirror).

(6) After diving, use quick adjustment buckle to loosen the fixed band of the mirror.

Common troubleshooting:

(1) Failure mode 1: water enters the mirror

Cause analysis:

A mirror skirt appeared pressure hair, pressure head cover;

B side mirror is too loose or too tight;

C) breathing through the nose;

Troubleshooting:

A. After wearing the face mirror, check whether the hair and head cover press the skirt of the face mirror;

B. Adjust the face mirror to appropriate tightness;

C Develop the habit of breathing through your mouth.

(2) Failure mode 2: The tightness of the mirror cannot be adjusted

Cause analysis:

A quick adjustment buckle is damaged;

B side mirror fixed belt pulling direction is wrong;

Troubleshooting:

A scrap treatment;

B. The direction of the fixed belt of the drawing mirror should be the rear direction of both sides rather than the oblique rear direction;

(3) Failure mode three: the lens is broken

Cause analysis:

A mirror hit by hard objects resulting in damage;

Troubleshooting:

A replace or repair parts;

B Diving equipment maintenance service point or manufacturer maintenance.