ZT101Y Diving First Stage Head Regulator Brass Material Silver Appearance
Regulator First stages ZT101Y
Descriptions
Superbalance diaphragm type first stage head, external adjustable relative medium pressure, allowing technicians to quickly medium pressure fine tuning
The Marine grade brass body protects the internal components from water and contaminants while improving cold water performance
The triangulated high and middle pressure hole position provides abundant take over position, the main regulator and the standby regulator can be installed side by side horizontally without affecting each other
Specifications
Ports | 4 medium pressure ports 3/8 "to 24UNF thread size, 2 high pressure ports 7/16" to 20UNF thread size/fixed medium pressure hole size |
Relative medium pressure | 0.9±0.1mpa |
Model | Balanced diaphragm type |
Type | DIN/INT is optional |
Average output flow | 1000 L/min |
Weight | 590 g /DIN |
Warning
(1) Do not assemble the low pressure tube on the high pressure hole of the first level unloader (with HP), nor connect the high pressure tube to the low pressure outlet of the first level unloader.
(2) The two-stage compressor is the medium-pressure air from the low-pressure outlet of the first-stage compressor, and the pressure is 0.95± 0.05mpa.
Select the high pressure pipe and medium pressure pipe to connect the hole.
Turn the high pressure plug and low pressure plug counterclockwise using a hex wrench.
Reserve these high and low pressure plugs for future use.
Base some lubricating oil to end thread of tube and o-ring (silicone oil may also be used, but silicone oil equipment should not be used on high oxygen diving).
Turn the pressure pipe clockwise to the corresponding outlet and use the torque tool to tighten the torque value. The torque value of the tool should be 40in-lbs.